The use of electric shear

(1) If you trim longer hair, it is best to cut long hair short with manual scissors first, and then use electric scissors for trimming.

(2) install and remove the electric shears, be sure to disconnect the power switch, otherwise, easy to be cut.

(3) when the noise of the electric shears is large or the blade vibrates violently, a ingot screw next to the electric shears can be loosened back, and check whether the screw pressing the blade is too loose. The loose screw should be tightened appropriately, but not too tight.

(4) if the hair is rolled to form three white channels, which means that there is a leakage of hair, due to small or no vibration force caused by, at this time, the electric shearing side of the ingot screw can be tightened a little.

(5) often add lubricating oil to the blade to reduce the dry friction and excessive fever between the upper and lower blades.

(6) the edge and gap of the upper and lower blades, easy to hide dandruff, dandruff, dust or other debris, after each use, the application of small brush clean.Because the hair that cuts off and the solidification of skin oil, can hinder the movement of scissors and its sharp degree, reason should often brush the sundry that remains on the edge.

(7) should not be in the bath or wet occasions to use the electric scissors, also do not use warm hand plug (pull) plug, otherwise easy to get electric shock.For the electric shears of 220V power supply with three core wires, it is necessary to ensure that the socket end of the ground wire matches well with the plug.

(8) after use to cut off the power supply, on the upper and lower blade coated with some anti-rust oil, the next time to use the lubricating oil should be wiped off.If not used for a long time, it should be coated with lubricating oil, covered with a protective cover, and properly stored in a box.

(9) Do not use sprinkling essence, water or other volatile chemicals to wipe clean.